Subaru XT 1988 Service Manual page 1277

WIRING DIAGRAM AND TROUBLESHOOTING 6-3
Precautions in trouble diagnosis and repair of electric
parts
1) The battery cable must be disconnected from the
battery's (-) terminal, and the ignition-starter switch must be
set to the OF F position, unless otherwise required by the
troubleshooting chart.
2) Securely fasten the wiring harness with clamps and clips
so that the harness does not interfere with the body end parts
or edges and bolts or screws.
3) When installing parts, be careful not to catch them on the
wiring harness.
4) When disconnecting a connector, do not pull the wires,
but pull while holding the connector body.
5
Wrong
A25-1101
Fig.
7
5) To disconnect a lock type connector, press the lock
release lightly by hand. To connect, insert the connector until
it snaps and confirm that it is tightly connected.