Subaru XT 1988 Service Manual page 660

AUTOMATIC TRANSMISSION AND DIFFERENTIAL
3-2
2) Install and route the transmission harness.
Be careful not to damage the harness.
3) Install the control valve ASSY.
(1) Set the select lever in range "2".
(2)
Install the control valve by engaging the manual valve
and manual lever, then tighten the 19 bolts.
Tightening torque:
8 ±1 N.m (0.8 ± 0.1 kg-m, 5.8 ± 0.7 ft-Ib)
~
Short bolt (Yellow) 11 pes
. . Long bolt (Black) 8 pes
Fig. 263
a. Be careful not to pinch the harness roll the gasket.
b. Tighten the control valve mounting bolts evenly.
L3·1014
4) Install the oil strainer to the control valve. Be careful not
to cut or break the a·ring. Then tighten bolts.
Tightening torque:
8 ± 1 N·m (0.8 ± 0.1 kg·m, 5.8 ± 0.7 ft·lb)
Fig. 264
5) Secure five connectors.
Fig. 265
Oil strainer
L3·769
For Duty Sol. A
r==-+T-:+r-
For Sol. 2 (shift)
For. Sol. 1 (shift)
• Sol. 3 (shift)
For Duty Sol. B
For A TF temp.
sensor
L3·543
6) Install the oil cooler outlet pipe, and secure with two
bolts.
Tightening torque:
8 ± 1 N'm (0.8 ± 0.1 kg·m, 5.8 ± 0.7 ft·lb)
Fit the pipe into position. Be careful to avoid twisting.
7) Install the oil pan.
(1) Attach the magnet at the specified position.
L3·772
Fig. 266
133