Subaru XT 1988 Service Manual page 1156

5-3
SEATS, SEAT BELTS, AND INTERIOR
Seat Belts
Front Seat Belts (Automatic Shoulder Belt)
Rail
&
Motor Assembly
In case the connector to the automatic shoulder belt has been
disconnected for repairs of the automatic shoulder belt or
related parts or for repairs of other parts, be sure to disconnect
the battery and reset the control unit.
If the connector of the automatic shoulder belt control unit or
the connector of the front or rear limit switch has been dis-
connected once during repairs, the control unit can enter the
failure mode when the connector is reconnected, making the
automatic shoulder belt inoperative.
REMOVAL
1) Push emergency release button on the shoulder anchor
and remove belt.
Fig. 28
2) Remove rear seat cushion and backrest.
3) Remove front pillar trim panel, rear quarter trim panel
(upper and lower) and roof trim.
4) Disconnect the connector of the front limit switch, rear
limit switch and motor.
L5-661
Fig. 29
14
5) Remove M6-bolts which hold side rail and motor ASSY.
L5-662
Fig. 30
Fig. 31
DISASSEMBLY
FRONT LIMIT SWITCH
1) Remove screw and slide it in direction of the arrow.
Fig. 32
Front limit switch
bracket
L5-664