Subaru XT 1988 Service Manual page 1264

6-2
BODY ELECTRICAL SYSTEM
Control Cable
ADJUSTMENT
a. Do not bend the control cable too sharply; otherwise, it
will not operate smoothly.
b. When installing the cam to the inner end of the control
cable, do not bend or crush the inner cable.
Cable inner
Throttle cam
Throttle lever
Fig. 84
Cable outer end
Adjusting nut
[Tightening torque:
6.4 - 11.3 N·m
(0.65
-1.15
kg-m, 4.7 - 8.3 ft-Ib))
Cruise control actuator cable
When securing the cable outer end, adjust the clearance
between the throttle cam and the lever to 0 to 2 mm
(0 to 0.08 in) using the adjusting nut. Ensure that there
is no free play between the throttle cam and the cable.
L6-1506
Vacuum Pump and Valve
1) Removing air cleaner and air flow meter.
REMOVAL
(1) Loosen hose clamp.
(2) Remove boot from air flow meter.
(3) Undo clips on air cleaner cover.
(4) Place air cleaner cover together with air flow meter
a. Ensure ignition switch is OFF.
on the engine.
b. Be careful because exhaust system and turbocharger tem-
peratures are high while engine was operating.
c. Always keep air cleaner, vacuum hose, etc. free from dirt
and dust.
54