Subaru XT 1988 Service Manual page 1005

PEDAL SYSTEM AND CONTROL CABLES
4-5
1 Stroke at cable end
2 Pedal bracket
3 Accelerator pedal
4 Stroke at pedal pad
5
Pin
6 Toe board
7 Accelerator cable
Fig. 7
CD
REMOVAL AND DISASSEMBLY
1) Disconnect ground cable from battery.
2) Disconnect accelerator cable from throttle body.
L4-680
3) Disconnect/detach clutch cable from the following parts.
( 1) Clutch release fork
(2) Clamp on transmission case
(3) Grommet of toe board
4) Detach trim panel and lower steering column.
5) Disconnect the following parts from pedal bracket.
(1) Operating rod of brake booster
(2) Electrical connectors (for stop light switch. etc.)
(3) Accelerator cable
Be careful not to kink accelerator cable.
6) Remove pedal bracket ASSY along with clutch cable
while supporting brake booster in engine room.
7) Detach following parts from pedal bracket ASSY.
(1) Accelerator pedal return spring
(2) Accelerator pedal
(3) Clutch cable
(4) Brake pedal return spring
(5) Clutch pedal return spring (vehicle with Hill-Holder)
(6) Circlip retaining pedal shaft
(7) Clutch pedal and brake pedal
(8) Stop light switch
INSPECTION
1) PEDAL SHAFT AND BUSHING
1) Clean off grease and dust. and inspect for wear and
damage.
7
2) Inspect play between bushing and shaft; replace bushing
and/or shaft with new one if defective.
Fig. 8
Fig.
9
2) ACCELERATOR PEDAL
Clean all parts and inspect for wear and damage.
Replace it with new one if defective.
Fig. 10
A20·040
A20-D41
L4·211