Subaru XT 1988 Service Manual page 1006

4-5
PEDAL SYSTEM AND CONTROL CABLES
3) STOP LIGHT SWITCH
Inspect switch stroke and operation.
If operation is not smooth and/or stroke is not with in specified
value, replace it with new one.
1.8 - 3.3
mm
(0.071 - 0.130 inl
PuSh. , .. -
A20-OO9
Fig. 11
ASSEMBLY
1) Attach stop light switch, etc. to pedal bracket temporarily.
2) Clean inside of bores of clutch pedal and brake pedal,
apply grease, and set bushings into bores.
3) Align bores of pedal bracket, clutch pedal and brake
pedal, attach brake pedal return spring and clutch pedal return
spring (vehicle with Hill·Holder), and then install pedal shaft
completely to prevent it from rotating.
Clean inside of bushes and apply grease before installing shaft.
4) Clean and apply grease to shaft and inside of bore of
accelerator pedal. Install accelerator pedal onto pedal bracket.
5) Set brake pedal position by adjusting position of stop
light switch.
A20-Q53
Fig. 12
8
Torque (Lock nut):
5.4 - 9.3 N·m (0.55 - 0.95 kg-m, 4.0 - 6.9 ft-Ib)
6) Connect clutch cable to clutch pedal by using clevis pin
and clip.
Clamp bolt torque:
5.9 - 8.8 N·m (0.60 - 0.90 kg-m, 4.3 - 6.5 ft-Ib)
For connection of clutch cable of 2700 cc model, see the topic
"Clutch Cable".
INSTALLATION
1) Insert clutch cable into hole on toe board, and set pedal
bracket above steering column.
Be careful not to bend clutch cable too much.
2) Insert bolts of brake booster into holes on toe board,
support it from engine room, and fit holes of pedal bracket
onto the bolts.
At this time, operating rod of brake booster should be engaged
with brake pedal.
3) While pushing pedal bracket upward firmly, tighten 4 nuts
and 2 bolts at its upper surface.
Tightening torque:
13 - 23 N'm (1.3 - 2.3 kg-m, 9 -17 ft-Ib)
4) Connect operating rod of brake booster to brake pedal
using clevis pin and snap pin.
1 Clevis pin
2 Snap pin
3 Operating rod
Fig. 13
A20-Q83
I