Subaru XT 1988 Service Manual page 1150

5-3
SEATS, SEAT BELTS, AND INTERIOR
Inner Trim
Door Trim
The front and rear door trims are made up of formed core
materials at the window shoulder location with soft formed
covering materials pasted over the core material. Trims used in
other areas consist of a board, cushion and covering material
pasted. The covering material used with trims is either chloride
vinyl, tricot or moquett, depending on the specifications.
Some lower trims are equipped with carpets.
Trim Panel and Side Sill Cover
1) The trim panel and side sill cover is a polypropylene,
injection-molded type to provide a fresh appearance.
2} A sealing material is installed on the front and rear pillars
to improve noise-proofing.
~
tdm
Sealing material Pillar trim
L5-653
Fig. 16
8
3) Urethane material is installed around the rear surface to
prevent booming noise and entrance of dust and dirt. An
insulator is also used, depending on the specifications.
4) The covering material used for the roof trim is tricot to
provide a good outward appearance.
Floor Mat
The front and rear floor mats are a one-piece, wall-to-wall
type, which have a noise and heat-insulator on the back side.
Foamed chloride vinyl mat, needle punch carpet, and cut-pile
carpet are also available for installation, depending on the
specifications.