Subaru XT 1988 Service Manual page 1127

5-2 DOORS AND WINDOWS
Door Glass
REMOVAL
1 ) Remove trim panel.
2}
Remove remote ASSY.
3}
Remove sealing cover.
4)
Remove rearview mirror from door.
5}
Remove outer weatherstrip.
6)
Remove inner stabilizer.
For details of above six items, refer to respective descriptions.
7)
Loosen upper stopper bolt from the front of door and
glass stoppers, and move door glass. Then, remove upper
stopper from the rear of door. Remove two bolts which hold
glass holder to regulator slider.
Bolts attaching glass holder
to regulator slider
I
L5-274
Fig. 21
a. When removing bolts on regulator slider, move glass to
position where bolts can be seen through service hole.
b. Mark position and tightening allowance of upper stopper
bolts before removal. This
will
make adjustment after installa-
tion easy.
B)
Open door, hold door glass with both hands and pull it
straight up from door panel.
Do not turn regulator in direction th8t closes window after
door glass has been removed. This will dislocate slider and
slider will scratch corner roller.
INSTALLATION
Installation is in the reverse order of removal.
Tightening torque:
Joining regulator slider
5.4 - 9.3 N·m (0.55 - 0.95 kg-m, 4.0 - 6.9 ft-Ib)
Put bottom of glass holder on regulator slider properly.
12
Window Regulator
REMOVAL
1)
Remove trim panel.
2) Remove remote ASSY.
3)
Remove sealing cover.
4)
Remove rearview mirror from door.
5)
Remove outer weatherstrip.
6)
Remove inner stabilizer.
7)
Remove front and rear upper stoppers from door.
8)
Remove door glass.
9)
Remove wire clip (manual type only).
10)
Remove regulator base plate and regulator rail.
Fig.
22
11)
Take out regulator ASSY through service hole in under-
side of door.
INSPECTION
Make following checks and replace parts if defective.
1) Worn gears.
2)
Broken springs.
3)
Damage and wear on other component parts.
4)
Lubrication of sliding parts.
L5-276
Fig.
23