Subaru XT 1988 Service Manual page 867

STEERING SYSTEM
4-3
SHAFT ASSEMBLY
1) Remove wing bracket ASSY
@
and telescopic shaft
@'
(Refer to "Disassembly of telescopic portion.")
2) Remove dust seal
@
by piercing with a sharply·pointed
tool such as a scribing punch.
Do not pry off dust seal with a screwdriver, etc. Also, do not
reuse dust seal when assembling shaft ASSY.
CD
Sensor plate
L4-1410
Fig. 30
3) With pipe ASS,Y
CD
pushed in direction of arrow, remove
snap ring
®
and washer
@.
Next, remove bolt
@,
washer
@,
and spacer
®,
and remove shaft ASSY
®
by pulling
downward (in direction of arrow).
1
I
~
I
rn
)
@ r
I
®
I
I
,
FF=
1
I
L4-71D
Fig. 31
Be careful not to damage sensor plate when removing shaft
ASSY
®.
Sensor plate is pressed into place.
21
4) Remove snap ring
@.
Then remove washers
@
and
@ ,
spring
@,
and housing
@.
5) Remove bearing·
@
from housing
@.
Remove bushing
@
from housing
@
by prying with a screwdriver, etc.
a. Do not reuse bushing.
b. Be careful not to scratch inside of housing.
PIPE ASSEMBLY
1) After removing bearing
@
and bushing (telescopic)
®,
remove bushing (bearing)
@
by prying with a screwdriver, etc.
Be careful not to scratch inside of pipe. Also, do not reuse
bushing (bearing).
® ®
@
~;;l;=k
L4-711
Fig. 32
2) Remove guide
@
from pipe by inserting screwdriver into
them.
L4-712
Fig.
33