Clutch - Subaru XT 1988 Service Manual

No.
2
3
4
Parts
Clutch cover CP.
Clutch release bearing.
Since this bearing is grease-
sealed and is of a non-
lubrication type, do not
wash with gasoline or any
solvent when servicing the
clutch.
Clutch release lever.
CLUTCH
Inspection
Visually check for the following items
without disassembling.
1) Loose thrust rivet
CD.
2) Damaged or worn bearing contact
area at center of diaphragm spring
®.
3) Damaged or worn disc contact
surface of pressure plate
®.
4)
Loose strap plate setting bolt
@.
5) Worn diaphragm sliding surface
®.
A12-437
Fig. 6
(1) Smoothness of rotation
Rotate bearing applying pressure in
thrust direction.
(2) Wear and damage of holder sur-
face contacting with lever.
(3) 4WD
Check the bearing ASSY for smooth
movement by applying force in the
radial direction.
Fig. 7
Holding bearing case,
apply force in the
radial direction.
Stroke: approx.
1.6mm
(0.063 in)
L2·216
Check lever pivot portion and the
point of contact with holder for wear.
7
2-10
Corrective action
Repair or replace.
Repair or replace.
Repair or replace.
Replacing of clutch release bearing
(FWD only)
1) Remove bearing out of holder.
2)
Press bearing.
Do not depress outer race.
1 PRESS (899754112)
2 Bearing (Clutch release)
3 Holder (Release bearing)
Fig. 8
Repair or replace.
A11·007