Subaru XT 1988 Service Manual page 1102

r
5-1
POINTS TO CHECK
11~\"~tif:~~~~£~"<·'; ~. ;',ff'~1~~
. "
2) Clinched section of safety lever for rust formation and
balky movement of safety lever due
to
improper sta~ng.
3) Other levers and spring for rust formation and unsmooth
movement.
Hood Lock Release Cable
REMOVAL
1)
Remove clamp fro,nlqck ASSY and disconnect cable end
from lever. .
2) Remove clips from radiator panel and cable from clips.
3) Remove cable clamps from engine compartment.
Trunk ·Lid
REMOVAL
Open trunk lid. Remove trunk' lid Motlntingbolts and detach
trunk lict1rom·hingeS.
4) Remove lower trim panel from instrument panel. Refer to Fig. 31
the "Instrument panel lower trim panel" section.
5) Remove tapping screws which hold cable bracket to front
pillar. and detach bracket.
24
INSTALLATION
Installation is in the reverse
order
of removal.
ADJUSTMEN
r
1)
To adjust left-right lid positioning, loosen bolts which
hold trunk lid to hinges.
2) To adjust up-down lid alignment, place washer(s' between
trunk lid'andhinges or meve trunk,lock'ASSY,upor dowri.
Torsion Bar
REMOVAL
1) Open trunk tid. Remove torsion bars from hinge' links
using REMOVER (926661000) ..
2) Remove the torsion bar
fr~
. bracket using REMOVER
(926661000). "',;'
CAUTION:
8. cmful baCIUJI tomon bar 'quicldy_nas back when
ral ... d.
,/