Subaru XT 1988 Service Manual page 1161

I'"
I
SEATS, SEAT BELTS, AND INTERIOR
5-3
5) Remove caps from the side of console box.
Rear Luggage Shelf
6) Open console box lid and remove screws from bottom
of console box.
Fig. 47
7) Remove screws from the side of console box.
8) Disconnect switch harness connectors, and move console
box back and up.
Fig.
48
INSTALLATION
I nstallation is in the reverse order of removal.
Do not allow wiring harnesses to get caught in console box
when installing.
19
REMOVAL
1) Remove rear seat cushion and backrest.
2) Remove rear pillar upper trim panel.
3) Disconnect harness connector for "H igh·mount stop
lamp".
4) Remove eight clips which hold rear luggage shelf, and
detach rear luggage shelf.
[If equipped with mat, use CLIP PULLER (925580000) to
remove eight clips.)
INSTALLATION
Installation is in the reverse order of removal.
Inner Trim
Front Pillar Upper Trim Panel
REMOVAL
1) Remove assist rail from passenger seat side.
2) Pull trim panel down at side rail location, and remove
resin clips.
Front pillar upper
trim panel
Fig. 49
3) Pull trim panel at front pillar location, and remove the
sheet metal clip from car body.
4) Slide trim panel back and remove.