Subaru XT 1988 Service Manual page 469

3-1 MANUAL TRANSMISSION AND DIFFERENTIAL
1 st driven
gear CP
Unit: mm (in)
9.5
(0.374)
Fig.
58
1st-2nd shifter fork
Unit: mm (in)
Fig. 59 3rd-4th shifter fork
5th drive gear
Fig. 60 5th shifter fork
8) Inspection of rod end clearance
Reverse driven gear
2nd driven
gear CP
L3-869
L3-141
L3-142
Measure rod end clearances A and B. If any clearance is not
within specifications, replace rod of fork as required.
A:
3-4 - 5 0.6 - 1.4 mm (0.024 - 0.055 in)
B: 1-2 - 3-4 0.5 - 1.5 mm (0.020 - 0.059 in)
36
'-----c:. _ _ _ _ _ _ _ _ _
L3-143
Fig. 61
9) Wipe off grease, oil and dust on the mating surfaces of
transmission cases with white gasoline, and apply liquid gasket
(Fuji Bond
"C"
or equivalent), and then put case
(RH)
and
(LH) together.
10) Tighten 17 bolts with bracket, clip, etc. in the following
sequence.
• 10 mm bolt
Fig.
62
Tightening torque:
8 mm bolt
A12-369
23 - 26 N·m (2.3 - 2.7 kg-m. 17 - 20
ft-Ib)
10 mm bolt
36 - 42 N·m (3.7 - 4.3 kg-m. 27 - 31
ft-Ib)
a. Insert bolts from the bottom and tighten nuts at the top.
b. Put cases together so that drive pinion shim and input shaft
holder shim are not caught up in between.
c. Confirm that counter gear and speedometer gear are
meshed, and high-low shifter shaft is inserted perfectly.
11} Tighten ball bearing attaching bolts at the drive pinion
rear.
Tightening torque:
26 - 32 N·m
(2.7 - 3.3 kg-m, 20 - 24 ft-Ib)