Subaru XT 1988 Service Manual page 713

TRANSMISSON CONTROL SYSTEM
3-3
3) Adjust the inner cable length.
(1) Push select lever arm in the "W" direction with a
force of 2.0 - S.9 N (0.2 - 0.7 kg, 0.4 -" 1.5 Ib) until
nut
®
contacts the connector.
----t..--Arm
•
W
Connector
L3491
Fig.
38
(2) While firmly grasping nut
®
with a wrench, tighten
nut
@.
Tightening torque:
13 - 23 N·m (1.3 - 2.3 kg·m, 9 - 17 ft·lb)
15
4) After completion of the fitting, make sure that the lever
operates smoothly all across the operating range.
5) Connect the harnesses and check the following items.
(1) The engine starts operating when it is in positions "P"
and "N", but not in other positions.
(2) The back-up lamp is lit when it is in position "R",
but not in other positions.
(3) The above starting and lighting are not performed at
the same time.
(4) Check that select lever does not move from "N" to
"R" without pushing the button.
(5) Check that select lever does not move from "R" to
"P" without pushing the button.
(S) Check that select lever does not move from "P" to
"R" without pushing the button.
(7) Check that select lever does not move from "3" to
"2" without pushing the button.
S) Fit the console.