Subaru XT 1988 Service Manual page 911

STEERING SYSTEM 4-3
2) Rear body
(1) With front body clamped in
vise, remove
four bolts to
separate rear body.
(2)
Remove
gasket.
Front body
Rear body
Gasket
L4-1230
Fig. 167
3) Cartridge ASSY
(1) Remove cartridge ASSY from front body.
(2) Cartridge ASSY consists of a rotor, ten vanes and a
cam.
~Vane
B~
. ~ ~
Pressure plate
~ ~
0
0
0
00
0
0
.
Cam rmg
Fig. 168
4) Pressure plate
(1) Remove pressure plate and a-ring.
(2) Remove pin from pressure plate.
L4-1231
65
5) Front body
(1) Remove retammg ring from inner groove on the
pulley side of front body. Remove drive shaft by tapping
the end (on the cartridge side) with a plastic hammer.
(2) Remove oil seal using a standard screwdriver.
a. If shaft is hard to remove, tap it with a plastic hammer.
b. Use care to prevent damaging or denting front body end
face or front body internal surface which is sealed.
c. Note that bearing is non-reusable.
o
L4-1233
Fig. 169
6) Oil seal
Using a screwdriver. pry off oil seal fitted into front body.
Use care to prevent damage to front body internal surfaces.
L4-1234
Fig. 170