Subaru XT 1988 Service Manual page 1129

5-2
DOORS AND WINDOWS
Auto-Door Lock Switch Door Striker
REMOVAL
REMOVAL
1) Remove trim panel. Remove door striker by loosening two screws.
2) Remove sealing cover.
3) Remove remote ASSY.
4) Close window completely.
5) Remove clip from latch. Remove two screws which hold
auto-door lock switch, and remove harness clip, The switch
can then be extracted through lower access hole.
L5-632
Fig.
26
6} Disconnect switch from harness.
Be careful not to damage harness when extracting switch
ASSY.
INSTALLATION
Installation is in reverse order of removal.
Tightening torque:
5.4 - 9.3 N·m (0.55 - 0.95 kg-m, 4.0 - 6.9 ft-Ib)
Auto-Door Lock Actuator
INSTALLATION AND REMOVAL
Use the same procedures as for auto-door lock switch.
14
I
/
/--- L5·633
Fig. 27
Tightening torque:
10 - 18
N'm
(1.0 - 1.8
kg-m,
7 -13
ft-Ib)
ADJUSTMENT
When door does not fit well or close well at rear end, move
striker sideways.
Door
Fig.
28
+
'+
Rear quarter
L5-278