Subaru XT 1988 Service Manual page 1252

6-2 BODY ELECTRICAL SYSTEM
Tightening torque:
Motor fixing bolts
13 - 23 N·m (1.3 - 2.3 kg-m, 9 - 17 ft-Ib)
Headlight cover fixing screws
3 - 6 N·m (0.3 - 0.6 kg-m, 2.2 - 4.3 ft-Ib)
2) Install retractable headlights so that the clearance between
lid, hood and fender is within the range indicated in the
following figure.
r
Front fender
4.S(0.181)
I
I
1
.-f.1----5.1 (0.201)
J
5.1 (0.201)
(Engine hood)
Unit: mm (in)
LS-512
Fig. 58
3) After adjusting the headlights, recheck them for proper
movement.
Wiper and Washer
ON-CAR SERVICES
ADJUSTMENT
1) When wiper switch is in "OFF" position, adjust blades in
original position as shown in illustration by changing wiper
arm installation.
Lifter
Section A-A
L6-539
Fig. 59
42
2) Adjust washer ejecting point on windshield glass as shown
in illustration when car stops.
450t50 (17.72t1.97)
Unit: mm (in)
L6-179
Fig. 60
REMOVAL
BLADE
Remove attaching screws and separate blade from wiper arm.
Blade
L6-181
Fig. 61
ARM
With front hood opened, remove nut and take out wiper arm
and arm cover.
LS-887
Fig. 62