Subaru XT 1988 Service Manual page 681

3-2 AUTOMATIC TRANSMISSION AND DIFFERENTIAL
4) Disconnect solenoid valve connectors.
Remove connectors from clips and disconnect connectors at
5 places.
For Duty Sol. A
1Jj~+J.;:-P.r-
For Sol. 2 (shift)
For Sol. 1 (shift)
For Duty Sol. B
~:r::<~WbWLL For A TF temp. sensor
Fig. 291
5) Remove duty solenoid B.
(1) Remove the four bolts.
(2) Remove solenoid.
Fig. 292
6) Remove oil strainer.
(1) Disconnect oil pipe by removing the two bolts.
(2) Remove four bolts and oil strainer.
Fig. 293
L3·543
L3·544
Be careful because oil flows from oil strainer.
7) Remove valve body.
(1) Remove 8 long bolts (Black).
(2) Remove 11 short bolts (Yellow).
Be careful because oil flows from valve body.
L3-978
Fig. 294
8) Remove shift solenoids 1, 2, and 3, and duty solenoid A.
Solenoid ASSY
Fig. 295
• Installation
1) Install duty solenoid B (lock-up).
Solenoid-l (shift)
Solenoid-3
(overrunning clutch)
L3·618
Tighten bolts shown by solid arrows. The two bolts and
brackets shown by arrows" • " must be tightened later.
154