Subaru XT 1988 Service Manual page 980

BRAKES
4-4
5) Slowly put the piston into the caliper body, and fit the
piston boot into the undercut of the piston just before the
piston is completely inserted.
K14-045
Fig. 82
6) Uniformly apply NIGLUBE RX-2 GREASE (725191040
or 003606000) to the whole sliding surface of the pin, and
boot-fitting undercuts of the pin and the support. Then install
the boot and pin to the support.
Apply NIGLUBE RX-2 GREASE
L4..Q61
Fig. 83
7) Install the pad, and pad spring to the support. (Refer to
SUb-section, "Replacement of pad.")
After installing the pad, make sure that the pad is held down
by spring force.
8)
Install the support to caliper body.
INSTALLATION
1) Install caliper ASSY to trailing arm with bolts.
Bolt tightening torque:
46 - 58 N·m (4.7 - 5.9 kg-m, 34 - 43 ft-Ib)
33
2) Connect the brake hose and bleed out air.
Tightening torque:
Brake hose
16 - 20 N'm (1.6 - 2.0 kg-m, 12 - 14 ft·.b)
Bleeder screw
7 - 9 N'm (0.7 - 0.9 kg·m, 5.1 - 6.5 ft·lb)
The brake hose must be connected without any twist
3) After the installation is completed, depress the brake
pedal several times to see that the braking system is not
leaking any fluid.
Rear Drum Brake
(1800
cc
FWD model)
REMOVAL
1)
Remove brake drum. referring to chapter "WHEELS AND
AXLES".
2)
Unscrew brake pipe flare nut and disconnect brake pipe.
Fig.
84
3) Unscrew back plate installing bolts and remove brake
ASSY. Take care so that spindle shaft and bearing are free
from dust.