Subaru XT 1988 Service Manual page 836

WHEELS AND AXLES
4-2
4) Install DOJ inner race on shaft and fit C-type snap ring 9) Align the outer race track and ball positions and place in
with special pliers. the part where shaft, inner race, cage and balls are previously
Confirm that the C-type snap ring is completely fitted in the
shaft groove.
A16-199
Fig. 38
5) Install cage, which was previously fitted, to inner race
fixed upon shaft.
Fit the cage with the protruded part aligned with the track on
the inner race and then turn by a half pitch.
1 Inner race
2 Cage
Fig. 39
CD
@
A16-022
6) Apply the specified grease 20 to 30 g (0.71 to 1.06 oz) on
the cage pocket.
7) Insert six balls into the cage pocket.
8) Fill 20 to 30 g (0.71 to 1.06 oz) of specified grease into
the interior of DOJ outer race.
21
installed, and then fit outer race.
Fig. 40
1 Outer race
2 Grease
A16-019
10) Install circlip in the groove on DOJ outer race.
a. Assure that the balls, cage and inner race are completely
fitted in the outer race of DOJ.
b. Exercise care not to place the matched position of circlip
in the ball groove of outer race.
c. Pull the shaft lightly and assure that the circlip is complete-
ly fitted in the groove.
Fig. 41
11) Add 20 to 30 g (0.71 to 1.06 oz) of specified grease to the
DOJ's interior.
12) Apply an even coat of the specified grease [20 to 30 g
(0.71 to 1.06 oz)] to the entire inner surface of boot. Also
apply grease to shaft.