Subaru XT 1988 Service Manual page 902

4-3
STEERING SYSTEM
Fig. 134
INSTALLER
(926300000)
y·packing
1'r':l~1---- Backup ring
L4·452
4) Drive ball bearing into place with REMOVER
(926290000) and a press. Use side 8 of REMOVER.
To facilitate installation, attach ball bearing to REMOVER and
insert into valve housing before using a press.
Fig. 135
5) Fill dust seal with grease.
Fig. 136
REMOVER
(926290000)
Ball bearing
L4-453
l4-454
6) Apply a coat of grease to the su rface of G U I DE
(926310000) and place GUIDE over end of input shaft. Also
apply grease to input shaft.
Insert pinion & valve ASSY into valve housing until the lip of
pinion oil seal touches valve housing.
Be sure GUIDE is free from scratches which would damage y.
packing.
GUIDE (926310000)
Grease::;=;
............ ----- Ix. x x ..
r---fF:=l1
Fig. 137
7) Push valve housing until it accommodates pinion
&
valve
ASSY.
L4-456
Fig. 138
8) Apply a coat of grease to the lip of dust cover and insert
dust cover until it butts up to the "graded" section of input
shaft.
56