Subaru XT 1988 Service Manual page 493

3-1
MANUAL TRANSMISSION AND DIFFERENTIAL
3) Select a snap ring so that side clearance between snap ring
(Inner-56) and ball bearing is 0 to 0.1 mm (0 to 0.004 in).
Snap Ring (Inner-56)
Part No.
Thickness mm (in)
805156020
1.75 ± 0.015 (0.0689 ± 0.0006)
805156021
1.83 ± 0.015 (0.0720 ± 0.0006)
805156022
1.91 ± 0.015 (0.0752 ± 0.0006)
L3407
Fig. 143
5) Install lock washer (20 x 30 x 3). Place splined end of
transfer driven gear in a vise and tighten lock nut (30
x
12) to
the specified torque. Lock lock nut at four points.
Tightening torque:
78 ± 6 N·m (8 ± 0.6 kg-m, 57.9 ± 4.3 ft-Ib)
L3409
Fig. 145
6) Install differential lock shaft, lock sleeve, fork and rod in
that order. Drive straight pin (5 mm dia. x 25) into place
4) Install transfer driven gear using PRESS and INSTALLER. through the hole for differential lock switch using REMOVER
2.
Tool No. Tool name
Tool No. Tool name
899580100 INSTALLER
899754112
PRESS
398791600 REMOVER 2
Be careful because press support is unstable.
a. Note the direction of the check ball groove in the rod.
b. Face dog clutch of differential lock sleeve toward the rear.
VJ~
/
/
L3408 L3-41 0
L -____
~~~
________
~
__
~
____
~~
______
~
Fig.
144
Fig. 146
60