Subaru XT 1988 Service Manual page 974

BRAKES
4-4
CD
1 Caliper body
2 Cone spring
3 Spindle
Niglube RX-2
Fig.
59
Spindle ASSY and grease application
A17-027
@
A17-223
a.
When the cone spring is replaced due to scratch, be sure to
replace the a-ring with a new one. Also, attach a new cone
spring before fitting the O·ring.
Six cone springs are incorporated. The assembling combination
is
as follows.
NA
--_._-
WJ
A 17-029
Fig. 60
b. After attaching cone springs, apply thin coat of SILICON
COMPOUND (725191050 or 003606010) to the a-ring, and
insert it with ADAPTER (925600000) with taking care to
prevent the a-ring from being damaged.
27
ADAPTER
(925600000)
Fig. 61 Fitting O-ring
A17-310
5) Apply N IGLUBE RX-2 GREASE (725191040 or
003606000) to the head of spindle ASSY and onto the inner
wall of needle bearings on caliper body in which lever &
spindle is to be fitted. After setting connecting link and
return spring, press a set of cone springs by PU LLER
(925471000).
Apply NIGLUBE RX-2 GREASE (725191040 or 003606000)
to grooves of lever & spindle in which lever cap and connecting
link are to be fitted. Then, fit connecting link into the groove
at the head of spindle. Insert lever
&
spindle provided with
lever cap and garter spring. Be sure to force in the hooked
portion of return spring to the groove of lever & spindle as
shown. Then, remove PULLER (925471000).
NIGLUBE RX-2
"' .
A 17·224
Lever & spindle
Niglube
RX.2-A---_-=~~~r____4
L4-049
Fig. 62 Grease application