Subaru XT 1988 Service Manual page 865

'.
STEERING SYSTEM 4-3
DISASSEMBLY
1) Remove pad ASSY from steering wheel as follows. Loosen
telescopic lever. With your hand, hold pad's concave portion
containing lever and pull it toward you.
2) Loosen nut on top of steering shaft, and remove tele-
scopic lever.
_'_I
Telescopic lever
L4-700
Fig. 20
3) Loosen nut securing steering wheel, and remove steering
wheel from shaft using a steering wheel puller.
Fig.
21
4) Loosen nut on meter bracket of steering column, and
remove combination meter ASSY.
Fig.
22
19
sr
Remove upper and lower steering column covers by
loosening four screws.
6) Remove control wing ASSY and combination switch
ASSY.
L4-785
Fig. 23
7) Remove two screws which secure steering sensor to
column and remove steering sensor.
TELESCOPIC PORTION
(Telescopic portion can be disassembled without removing
column ASSY from vehicle.)
L4-702
Fig. 24
1) Remove nut
®
and adjusting screw
@
in underside of
wing bracket ASSY
@'
Then, remove bracket
@
and
telescopic shaft
@
as a unit. .
2) Remove snap ring
@
and then shaft
@
from bracket
@.
3) From shaft
@,
remove lock key (telescopic)
@,
lock
shaft (telescopic)
(jJ)
and rod
@.