Subaru XT 1988 Service Manual page 1004

4-5 PEDAL SYSTEM AND CONTROL CABLES
SERVICE PROCEDURE
Pedal
ON-CAR SERVICE
1) BRAKE PEDAL
1} Check position of pedal pad.
If it is not within specified value, adjust it by adjusting brake
booster operating rod length.
Reserve distance (Remaining clearance):
More than 120 mm (4.72 in)/294 N (30 kg, 66 Ib)
Check free play by operating pedal by hand.
If it is not within specified value, adjust it by adjusting posi-
tion of stop lamp switch.
Be careful not to rotate stop lamp switch.
Brake pedal free play:
0.5 - 2.5 mm (0.020 - 0.098 in)
Floor mat
Unit: mm (in)
Stop lamp switch
Stop & brake switch
(for cruise)
Stroke
128.5 - 139.5
Remaining
---.'l.:!aR_~~;:,;;;:;~;;_
(5.06 - 5.49)
clearance ""
120(4.72) L4.1192
Fig.
4
2}
Apply grease to operating rod connecting pin to prevent
it from wearing.
2) CLUTCH PEDAL
1)
Check clutch pedal free play by operating pedal by hand.
If it is not within specified value, adjust it by turning adjusting
nut on engine side end of clutch cable.
Free play:
at clutch pedal pad
10 - 20 mm (0.39 - 0.79 in)
at center of cable on clutch release fork
FWD: 2 -
3
mm (0.08 - 0.12 in)
4WD: 3-4mm(0.12-0.16in)
6
Lock nut tightening torque:
5.4 - 9.3 N·m (0.55 - 0.95 kg·m, 4.0 - 6.9 ft·lb)
Fig. 5
Pedal play:
10- 20 mm (0.39 - 0.79 in)
Full stroke
4WD:
L 1.060
Free play
4WD:
3-4mm
25.5 - 27 mm (1.004 - 1.063 in)
FWD:
(0.12 - 0.16 in)
FWD:
2-3mm
(O.OS - 0.12 in)
1 Lock nut
2 Adjusting nut
3 Release fork
Fig. 6
17 - 18 mm (0.67 - 0.71 in)
A20.Q51
2)
Apply grease to connecting portion of clutch pedal and
clutch cable and contact point of clutch release fork and
clutch cable nut.
3) ACCELERATOR PEDAL
Check pedal stroke and free play by operating accelerator
pedal by hand.
If it is not within specified value, adjust it by turning nut con-
necting accelerator cable to throttle body.
Free play at pedal pad:
0-4 mm (0 - 0.16 in)
Stroke:
at pedal pad
at cable end
46 -
50 mm (1.81 - 1.97 in)
33 - 38
mm
(1.30 - 1.50
in)