Subaru XT 1988 Service Manual page 510

MANUAL TRANSMISSION AND DIFFERENTIAL
3-1
6) Install ball bearing.
1 INSTALLER (899874100)
2 Bear'lng
3 RETAINER (899714110)
Fig. 204
A12'()53
7) Assemble snap ring with PRESS ASSY (899754110).
1 PRESS ASSY (899754110)
2
Snap ring
3 Guide
Fig. 205
Part No.
805022010
805022011
805022012
805022013
805022014
805022015
805022016
805022017
805022018
805022019
805022030
805022031
A 12'()54
Thickness mm (in)
2.45 (0.0965)
2.48 (0.0976)
2.51 (0.0988)
2.54 (0.1000)
2.57 (0.1012)
2.60 (0.1024)
2.63 (0.1035)
2.66 (0.1047)
2.69 (0.1059)
2.85 (0.1122)
2.42 (0.0953)
2.39 (0.0941)
a. When reassembling a snap ring, always replace it with a new
one.
b. Select a suitable snap ring from the following table so that
the play in the axial direction is 0 to 0.05 mm (0 to 0.0020
in).
8) Assemble woodruff key and then 5th drive gear.
1 RETAINER (899714110)
2 INSTALLER (899754112)
Fig. 206
When assembling key, pay attention to the groove.
9) Tighten lock nut.
77
Tightening torque:
73 - 84 N·m
(7.4 - 8.6 kg-m, 54 - 62 ft-Ib)
1 HOLDER (898938600)
2 SOCKET WRENCH (899988608)
Fig. 207
After tightening the lock nut, stake it.
A12475
A12·145