Subaru XT 1988 Service Manual page 1145

SEATS, SEAT BELTS, AND INTERIOR
5-3
WALK·IN SYSTEM
When getting in or out of rear seat, front seat can be moved to
the forwardmost position as follows:
Depress pedal or lift reclining hinge lever to tilt backrest
forward. Wire cable connecting reclining hinge will then release
slide rail lock so that seat moves forward by helper spring.
Back rest
Reclining lever
L5-641
Fig. 4
HEADREST FORE·AND·AFT ADJUSTMENT
(XT -6 model only)
To adjust the headrest, hold it with both hands. Move it
in the fore-and-aft direction and release it at the desired
position. The headrest will lock in that position.
L5-642
Fig. 5
3
REMOVAL AND INSTALLATION OF
HEADREST (Exc. XT·6 model)
To remove the headrest, lightly turn lock release knob
(counterclockwise) located on the upper left side of the seat
backrest and lift out headrest.
To install, align headrest stays with the holes in the backrest
and push headrest in firmly.
When turning lock release knob, be careful not to damage the
seat cover.
t
.\.--_J~
L5-643
Fig. 6