Subaru XT 1988 Service Manual page 926

4-3 STEERING SYSTEM
3) Remove nuts and washers from brush lead terminals.
L4-1443
Fig. 214
4) Remove brushes while lifting brush springs.
L4-1440
Fig. 215
Always replace both brushes (positive and negative sides) as a
unit
ASSEMBLY
1) Lift brush springs and install new brushes.
~
!
L4-1442
Fig. 216
2) Install new brush terminals to stud bolts and tighten with
washers and nuts.
L4-1443
Fig. 217
3) I nstall washers and nuts to stud bolts and tighten.
Tightening torque:
3.9 - 5.1 N·m (0.40 - 0.52 kg-m, 2.9 - 3.8 ft-Ib)
4) Secure harnesses with washers and nuts.
Tightening torque:
3.9 - 5.1 N·m (0.40 - 0.52 kg-m, 2.9 - 3.8 ft-Ib)
a. Check that brushes face in the correct direction.
Tightening torque:
1.2 - 1.5 N.m (0.12 - 0.15 kg-m, 0.9 - 1.1 ft-Ib)
b. Be careful to install brushes properly because of their
polarity.
c. Always replace brushes (positive and negative sides) as a
unit.
80
INSTALLATION
1) Secure pump ASSY to bracket above front bulkhead with
bolts, and connect high and low pressure hoses.
Tightening torque:
23 - 42 N·m (2.3 - 4.3 kg-m, 17 - 31 ft-Ib)
~ ~ -~
~.~~~~
L4-1444
Fig. 218