Subaru XT 1988 Service Manual page 1162

5-3
SEATS, SEAT BELTS, AND INTERIOR
INSTALLATION
1) Be sure clips are securely installed on trim panel.
2) Align clips with holes in front pillar, and tap trim panel
until clips are fitted into body.
3) Align clips with holes at side rail location, and tap trim
panel until clips are fitted into car body.
4) Install assist rail on passenger seat side.
Use H5-bolts length 12 mm (0.47 in) (901010001) or equiv-
alent when installing assist rails.
Front Pillar Center Trim Panel
REMOVAL
Pull trim back and remove.
INSTALLATION
Insert lower side of center trim panel into lower trim panel
and push it against body flange.
Front Pillar Lower Trim Panel
REMOVAL
1) Remove clip which holds the right lower cover.
2) Pull trim panel back and remove.
Rear Quarter Upper Trim Panel
REMOVAL
1) Fold rear back rest forward. (On D L models, remove trim
back.)
2) Remove shoulder anchor bolt of seat belt.
3) Remove belt cover at outer belt outlet portion and
remove screw.
4) Remove clip from rear section of trim panel.
20
I
I
Fig. 50
/
/
.~1rimpanel
/
-
.
.
.:-
L5·681
5) Remove clips (6 places) which hold trim panel to car
body, using CLIP PULLER (925580000).
6) Disengage pawls from body flange at front section of trim
panel.
7) Slide trim panel forward and remove.
INSTALLATION
Installation is in the reverse order of removal.
Be sure pawls are securely attached to body flange at front
section of trim panel.
Rear Quarter Lower Trim Panel
REMOVAL
1) Remove rear back rest and cushion.
(On D L models, remove trim cushion and trim back instead.)
2) Remove rear quarter upper trim panel.
3} Remove clips (6 places) which hold lower trim panel to
car body, using CLIP PULLER (925580000).
Fig. 51