Subaru XT 1988 Service Manual page 842

WHEELS AND AXLES 4-2
5) Lock the ring nut by staking a point on the housing
surface facing the ring nut groove.
Fig. 55
6) Install outer oil seal by using special tool INSTALLER
(925530000).
Be su re to renew the oil seal.
7) Install inner oil seal by using special tool INSTALLER
(925530000).
Be su re to renew the oil seal.
8) Mount inner arm to vehicle body.
9) Install rear brake ASSY to inner arm, and connect brake
pipes etc.
L1-491
Fig. 56
Tightening torque (Back plate':
46 - 58 N·m (4.7 - 5.9 kg-m, 34 - 43 ft-Ib)
10) Connect brake hose and brake pipe.
27
Fig. 57
11) Temporarily fit brake disc, center piece, washer spring and
castle nut to spindle, in this order.
a. Play on spindle experienced, when mounting brake disc is
not a fault.
b. Don't confuse orientation of washer spring.
~aint mark
Nut side
.~.
Center piece side
Washer spring
Fig.
58
12) 'Bleed brake system.
1 Cotter pin
2 Castle nut
3 Washer spring
4 Center piece
A16-197
a. Before bleeding brake system, check pedal play and brake
fluid level in reserve tank.
b. Bleed air from four wheels without fail.
13) Tighten castle nut, insert cotter pin and bend it firmly
with foot brake applied to lock the wheel and axle.
Tightening torque:
196 N·m (20 kg-m, 145 ft-Ib)
After tightening castle nut to the specified torque, tighten
further within 30° to align holes on nut and spindle.