Subaru XT 1988 Service Manual page 1163

,.
SEATS, SEAT BELTS, AND INTERIOR 5-3
4) Slide lower trim panel forward and remove.
Rear Bulk Trim Panel
REMOVAL
1) Fold rear back rest forward. (On DL models, remove trim
back.)
2) Remove rear sides of rear quarter upper trim panel and
lower tri m panel.
3) Remove bolts which hold striker.
4) Remove clips (4 places) and stoppers (2 places) which
hold rear bulk trim panel to car body, using CLIP PULLER
(925580000) .
Rear bulk trim panel
L5-312
Fig. 52
5) Remove rear bulk trim panel from car body.
INSTALLATION
Installation is in the reverse order of removal.
Be sure upper section of rear bulk trim panel is placed betMen
rear luggage shelf and car body.
Side Sill Cover
REMOVAL
1) Remove rear seat cushion. (On DL models, remove trim
cushion).
2) Remove E LR unit of the manual lap belt.
3) Remove side cover plate.
4) Remove clips from side sill cover.
5) Remove tapping screws from side sill cover, and detach
side sill cover from car body.
21
INSTALLATION
Installation is in the reverse order of removal.
Do not allow harnesses and piping to get caught betlllJeen side
sill cover and car body during installation.
Trunk Mat
REMOVAL
1) Fold rear back rest forward. (On DL models, remove trim
cushion.)
2) Remove spare tire supporter and holder.
=
L6-683
Fig. 53
3) Remove clips which hold front side of trunk mat, and
detach trunk mat.
Rear Luggage Shelf
REMOVAL
1) Fold rear back rest forward. (On DL models, remove trim
back.)
2) Remove rear quarter upper trim panel.
3) Remove clips (10 places) which hold rear luggage shelf to
car body, using CLIP PULLER (925580000).