3-1
MANUAL TRANSMISSION AND DIFFERENTIAL
3)
Removing 5th drive gear
3)
Install 3rd drive gear, ring and sleeve & hub ASSY sub-
Remove 5th drive gear using REMOVER (899714110) and
assembled before_
TRANSMISSION MAIN SHAFT REMOVER (899864100)_
4)
Remove woodruff key.
Take care so that the insert is in line with the ring groove.
5)
Remove the following parts;
•
Ball bearing (23
x
58
x
27)
4)
Install 5th needle bearing race.
•
4th drive gear
•
Sleeve and hub assembly
•
3rd drive gear
CP
•
4th needle bearing race
1 REMOVER (899864100)
2 RETAINER (899714110)
Fig. 199
ASSEMBLY
1)
Assemble sleeve & hub ASSY.
A12-027
Make sure bent sections of springs on both sides are kept 180
0
apart and hooked at hub's holes.
L3-166
Fig. 200
Before assembling main shaft, apply transmission oil to needle
bearing, ball bearing and bushings sufficiently.
2)
Install 5th needle bearing race with the following special
tools.
INSTALLER (899874100)
RETAINER
(899714110)
Fig. 201
1 INSTALLER (899874100)
2 Race
3 RETAINER (899714110)
A12-050
5)
Install ring, 4th drive gear and 4th drive gear thrust
washer.
A12.Q51
Fig. 202
Pay attention to the assembling direction.
4th gear side
A12-260
Fig. 203
76