Subaru XT 1988 Service Manual page 417

ENGINE AND TRANSMISSION MOUNTING SYSTEM
2-11
General Precaution
1) Remove or install engine and transmission in an area
where chain hoists, lifting devices, etc. are available for ready
use.
2) Be sure not to damage coated surfaces of body panels
with tools or stain seats and windows with coolant or oil.
Place a cover over fenders, as required, for protection.
3) Prior to starting work, prepare the following:
Service tools, clean cloth, containers to catch coolant and oil,
wire ropes, chain hoist, transmission jacks, etc.
4) Lift up or down car when necessary. Make sure to support
the correct positions. (Refer to Chapter 1-3 "General Informa-
tion".)
Engine
REMOVAL
1) Open front hood and support with a stay.
L2-1123
Fig. 4
9
2) Reduce fuel pressure.
(1) Raise car positioned at side sill location.
(2) Disconnect fuel pump wiring connector.
Fig. 5
(3) Lower car to floor.
(4) Start engine.
(5) After engine has stopped, crank engine for approxi-
mately five seconds and then turn ignition switch to OFF.
(6) Raise car again.
(7) Connect fuel pump wiring connector.
3) Drain coolant.
(1) Loosen drain cock.
Fig.
6
(2) Lower car to floor.
(3) Place a container to catch coolant.
(4) Loosen radiator cap.
4) Disconnect ground cable from battery and engine side.