Subaru XT 1988 Service Manual page 651

3-2 AUTOMATIC TRANSMISSION AND DIFFERENTIAL
(9) If tooth contact 'is correct, mark the retainer position
and loosen it. After fitting the O-ring, screw in the
retainer to the marked position. Then tighten the lock
plate to the specified torque.
Tightening torque:
23 - 26 N·m (2.3 - 2.7 kg-m, 17 - 20 ft-Ib)
11) Install the seal pipe to the converter case.
Be sure to use a new seal pipe.
L3-729
Fig_ 231
12) Install two oil seals to the oil seal retainer with IN-
STALLER (499247300).
a. Pay attention to the orientation of the oil seals.
b. Be careful not to damage the seal lips. If any damage is
found, replace with a new one.
13) Attach the O-ring to the oil seal retainer with vaseline.
Install the seal to the oil pump housing bore.
L3-731
Fig_ 232
14) Install the oil seal retainer taking care not to damage the
oil seal lips. Then secure with three bolts.
Make sure the D·ring is fitted correctly in position.
Tightening torque:
7
±
1 N·m (0_7
±
0.1 kg-m, 5.1
±
0.7 ft·lb)
Oil seal retainer
L3-732
Fig.
233
15) Apply vaseline to the groove on the oil pump cover, and
install two (R) seal rings and two (H) seal rings.
a. Fit the seal ring after compressing, and rub vaseline into
the seal ring to avoid expansion.
b. The "R" seal ring has a large diameter, while "H" has small
diameter.
L3-733
Fig.
234
16) Install the rubber seal to the converter case.
Be careful not to lose the rubber seal.
124