Subaru XT 1988 Service Manual page 486

MANUAL TRANSMISSION AND DIFFERENTIAL
3-1
L3·373
Fig. 114
b. See p. 37
13) Checking tooth contact of hypoid gear.
See p. 37
14) Fit a·ring into the groove of retainer and tighten it into
the position where retainer has been tightened.
Carry out this job on both upper and lower retainers.
15) Selection of main shaft rear plate.
See p. 38
16) Install transfer case & shifter ASSY to transmission case.
While aligning differential lock sleeve, install transfer case.
L3·508
Fig. 115
17) Tighten selector arm.
18) Install in following order ba", reverse accent spring,
aluminum gasket and plug.
53
Fig. 116
19) Neutral position adjustment.
See p. 39
20) Reverse check plate adjustment.
See p. 40
21) Installing center differential & extension ASSY.
CD
Install transfer shifter rod on extension with a clip.
®
Install center differential & extension on transfer
case.
Fig. 117
®
Tightening the extension
Tighten the ten 10·mm bolts to secure extension.
Tightening torque:
37
±
3 N·m (3.8
±
0.3 kg-m, 27.5
±
2.2 ft-Ib)