Subaru XT 1988 Service Manual page 472

MANUAL TRANSMISSION AND DIFFERENTIAL
3-1
A
L3-147
Fig. 71
16) Transfer case & shifter ASSY
Secure transfer case & shifter ASSY to transmission case with
eight bolts.
Tightening torque:
25 N·m (25 kg·m, 18 ft·lb)
Be sure gasket is positioned on the rear of the case.
17) Tighten selector arm.
Secure selector arm to shifter arm CP with shifter fork screw.
Shifter arm CP should be caught by pawl of rod.
Tightening torque:
10
N'm
(1.0
kg·m,
7
ft·lb)
Fig. 72
39
18) I nstall ball (7.1438), reverse accent spring, aluminum
gasket and plug in that order.
L3-502
Fig. 73
Tightening torque:
10
N·m
(1.0
kg·m,
7
ft·lb)
19) Neutral position adjustment
(1) Shift gear into 3rd gear position.
(2) Shifter arm turns lightly toward the 1 st/2nd gear side
but heavily toward the reverse gear side because of the
function of the return spring, until arm contacts the
stopper.
(3) Make adjustment so that the heavy stroke (reverse
side) is a little more than the light stroke (1st/2nd side).
(4) To adjust, remove bolts holding reverse check sleeve
ASSY to the case, move sleeve ASSY outward, and place
adjustment shim (0 to 1 ea.) between sleeve ASSY and
case to adjust the clearance.
Be careful not to break D'ring when placing shim(s).
One shim's thickness: 0.15 mm (0.0059 in)
0.30 mm (0.0118 in)
• When shim is removed, the neutral position will move
closer to reverse; when shim is added, the neutral
position will move closer to 1st gear.
• If shims alone cannot adjust the clearance, replace
reverse accent shaft and re·adjust.
Reverse accent shaft
Part No. Mark Remarks
32188AA020
A
Neutral position is closer
to 1st gear.
32188AA002
No
Standard
mark
32188AA030 C
Neutral position is closer
to reverse gear.