Subaru XT 1988 Service Manual page 843

4-2
WHEELS AND AXLES
14) Install packing to differential spindle.
15) Engage DOJ of rear drive shaft to differential spindle.
a. When mounting, mate the spline teeth properly so that the
spring pin holes of DOJ and spindle will align.
b. When mounting the rear drive shaft ASSY, take care not
to mount the DOJ and BJ oppositely.
Fig. 59
DOJ
A16-106
70.5 mm
t - - - t -
t-I-t-t--+
(2.776 in)
dia.
BJ
L4-1115
16) Install packing to rear spindle, and mount BJ of rear
drive shaft onto rear spindle with trailing arm lowered all the
way.
Fig. 60
28
17) Drive spring pins into DOJ and BJ respectively.
a. Before driving in the spring pin, confirm alignment of the
holes.
b. Be sure to use new spring pin.
Fig. 61
18) Install wheels, outer arms, etc.
19) Lower vehicle. to the ground, and install lower end of
shock absorber to inner arm.
Fig.
62
Tightening torque:
88 - 118 N·m (9 - 12 kg-m, 65 - 87 ft-Ib)
20) Check and adjust rear vehicle hight and rear wheel align-
ment.