Subaru XT 1988 Service Manual page 654

AUTOMATIC TRANSMISSION AND DIFFERENTIAL
3-2
a. Pay attention to,the orientation of the dish plate.
b. Driven plate } 1800: 4
Drive plate 2700: 6
c. Dish plate 1800: 2
2700: 1
(2) Apply compressed air intermittently to check for
operation.
L3·744
Fig.
244
(3) Check the clearance (Selection of retaining plate)
Standard value:
1.1 -1.7 mm (0.043 -0.067 inl
Allowable limit: 2.7 mm (0.106 inl
Before measuring clearance, place the same thickness of shim
on both sides to prevent retaining plate from tilting.
• Available retaining plates
Part No.
Thickness mm (in)
31667AA180 6.5 (0.256)
31667AA190 6.8 (0.268)
31667AA200
7.1 (0.280)
31667AA210
7.4 (0.291)
31667AA220 7.7 (0.303)
31667AA230
8.0 (0.315)
31667AA240
8.2 (0.323)
31667AA250 8.4 (0.331)
11) Install the thrust needle bearing to the inner race.
Refer to
@]
"Location and installing direction of thrust
needle bearing and washer" for the orientation of the bearing.
Carefully check the orientation of all parts indicated
by
an
asterisk * in the following pages.)
12) Install the forward clutch drum ASSY.
(1) Install carefully while rotating the drum slowly
paying special attention not to damage the seal ring.
(2) Installation is complete when the drum recedes
2.5 mm (0.098 in) from the inner race surface.
2.5 mm (0.098 in)
Forward clutch drum
Inner race
L3·746
Fig. 245
13) Assemble the overrunning clutch hub.
a. Join the thrust needle bearing* and thrust washer with
vaseline, and then install them together.
b. Make sure that the splines are engaged correctly.
Thrust washer
Thrust needle bearing
L3·747
Fig. 246
14) Install the one-way clutch outer race ASSY.
Make sure the forward clutch splines are engaged correctly.
rc:t;/
Forward clutch
Fig. 247
127
c\
J
J
L3·74S