Subaru XT 1988 Service Manual page 837

4-2
WHEELS AND AXLES
13) Install DOJ boot taking care'Wpt to twist it.
a. The inside of the larger end of DOJ boot and the boot
groove shall be cleaned so as to be free from grease and other
substances.
b. When installing DOJ boot, position outer race of DOJ at
center of its travel.
14) Put a band through the clip and wind twice in alignment
with band groove of boot.
Use a new band.
15) Pinch the end of band with pliers. Hold the clip and
tighten securely.
When tightening boot, exercise care so that the air within the
boot is appropriate.
16) Tighten band by using BAND TIGHTENING TOOL
(925091000).
a. Tighten band until it cannot be moved by hand.
b. Former BAND TIGHTENING TOOL (925090000) is inter-
changeable vvith this 925091000.
Fig_ 42
BAND TIGHTENING TOOL
(925091000)
A16-201
17) Tap on the clip with the punch provided at the end of
BAND TIGHTENING TOOL.
Tap to an extent that the boot underneath is not damaged.
18) Cut off band with an allowance of about 10 mm (0.39 in)
left from the clip and bend this allowance over the clip.
19) Fix up boot on BJ in the same manner.
22
INSTALLATION (Except XT6)
1) Insert axle shaft into housing and attach spacer of
INSTALLER (925130000 or 922431000) on outer bearing
inner race taking care not to damage the oil seal lip.
2) Install transverse link ball joint to housing.
Tightening torque:
29 - 39 N·m (3.0 - 4.0 kg-m, 22 - 29 ft-Ib)
3)
Connect the rod of INSTALLER to the thread of axle
shaft and turn the handle while holding the rod end by means
of a spanner, thus axle shaft is pulled in.
4) Align the spring pin holes of DOJ and differential spindle.
5) Connect DOJ and differential spindle by driving spring pin
in.
a. Make sure that the holes are aligned before driving the
spring pin in.
b. When driving the spring pin, always use new one.
Fig. 43
6) Connect damper strut to housing, and tighten two bolts.
Tightening torque:
29 - 39 N·m (3.0 - 4.0 kg-m, 22 - 29 ft-Ib)
7)
Install disc cover on housing.
Tightening torque:
6 - 14 N·m (0.6 - 1.4 kg-m, 4.3 - 10.1 ft-Ib)
8) Install hub
&
disc ASSY to axle shaft.