Subaru XT 1988 Service Manual page 1201

6-1
ENGINE ELECTRICAL SYSTEM
2700cc model
DISASSEMBLY
1) Heat the bearing box to 50 to 60°C (122 to 140°F) with
a 100 W-soldering iron and remove the three through bolts.
Then insert the tip of a flat-head screwdriver into the gap
between the stator core and front bracket. Pry then apart to
disassemble.
Be careful not to lose the spring fitted in the periphery of the
rear bearing.
Soldering iron (100 W)
Bearing box
L6·1653
Fig.
41
Fig.
42
Pulley
L6-1655
Fig. 43
3) Remove the nut and insulating bushing at terminal B.
Remove the screws fastening the rectifier and the brush
holders to separate the stator from the rear bracket.
L6·1656
Fig.
44
4) Remove the IC regulator.
2) Remove the pulley nut. The pulley rotor and front L6-1657
bracket can be separated.
Fig. 45
20