Subaru XT 1988 Service Manual page 497

3-1
MANUAL TRANSMISSION AND DIFFERENTIAL
(6) Install lock washer (42
x
53
x
2). Install lock nut
(42 x 13) and tighten to the specified torque using
SOCKET WRENCH (50).
Tightening torque:
245
±
10 N·m (25
±
1 kg-m, 181
±
7 ft-Ib)
Fig. 161
a. Stake lock nut at two points.
SOCKET WRENCH
(499987300)
L3·423
b. Check that starting torque of roller bearing is 0.1 to 1.5
N·m (1 to 15 kg-cm, 0.9 to 13.0 in-Ib).
Spring balancer
L3-424
Fig. 162
64
3) Drive pinion shaft ASSY
(1) Install roller bearing onto drive pinion. Install washer
(33 x 50 x 5) using INSTALLER and PRESS.
o-!---INSTALLER
(499277100)
L3-425
Fig. 163
When installing roller bearing, note its directions (front and
rear) because knock pin hole in outer race is offset.
____ - - - - Roller beari ng
' - - - - Knock pin hole L3-426
Fig. 164
(2) Install thrust bearing (33 x 50 x 3) and needle bearing
(30 x 37 x 23). Install driven shaft ASSY.
L3-427
Fig. 165
I