Subaru XT 1988 Service Manual page 1133

5-2
DOORS AND WINDOWS
Glass Contact Adjustment
1 ) Loosen one of two upper adjusting bolts which hold
regulator rear sash and adjust glass contact pressure as
indicated in figure below. Tighten bolt.
Fig.
38
Adjusting bolt
(2 pes)
2) Adjust front sash, using step 1) above as a guide.
Adjustment amount of front and rear sashes is basically the
same; however, it may differ slightly due to the way the door
is aligned.
It is advisable to adjust both sash bolts as close to the center
of holes as possible.
Unit: mm (in)
18
IN
-
4.8
(0.189)
Center
pillar
L5-288