Subaru XT 1988 Service Manual page 1238

6-2
BODY ELECTRICAL SYSTEM
ALARM
ARRIVE
If the ALARM is set, the mark"
"») "
illuminates even if
another function is being displayed, and flashes when the preset
alarm time is reached.
Fig.
34
Time alarm
Alarm Time Resetting
L6-1268
1) When the ALARM button on the control unit is depressed, it illuminates.
If the ALARM is presetted, the mark " .))~ " and alarm time are displayed. This state con-
tinues until the alarm is cancelled. Neither AM nor PM flashes.
2) When the preset alarm time is reached, the buzzer sounds for six minutes or until the alarm
is cancelled even if another function is displayed on the display unit. (The buzzer issues a
sound four times a second.) At the same time, the mark"
.)~
" flashes once a second with
the duty ratio of 50% .
. . - - - - 1 Sec.
ON
OFF -
3) When the alarm time is being set, the mark
II
.»~"
illuminates even if another function is
being displayed.
4) When the ALARM switch is pressed, alarm stops.
5) In the ALARM mode, pressing the RESET switch cancels the "set" time.
1) With ALARM button depressed, the alarm time can be reset by pushing the "H", "10M",
and "M" switches. This resetting mode is cancelled 10 seconds after depressing these
switches, or when the "SET" switch is depressed. If other function button is depressed
within 1 0 seconds, this mode is cancelled after time setting.
2) If "12:" is displayed when the "H" switch is depressed, "AM" or "PM" changes as follows:
AM -+PM, PM -+AM.
3) If the "H", "10M", or "M" switch is helding the displayed number changes for each 0.5
second for the first 1.5 seconds, and for each 0.25 second afterward. When pushed once,
the displayed number changes by one.
28