Subaru XT 1988 Service Manual page 385

2-8 FUEL SYSTEM
Fuel Pump
REMOVAL
1) Release the pressure of the fuel system.
Refer to "REMOVAL
1)"
in Fuel Filter.
2) Keep the pump harness connector disconnected.
3) Jack up the vehicle.
4) Clamp the middle portion of the thick hose connecting
the pipe (coupling) and pump. Prevent the fuel from flowing
out of the fuel tank.
Do not bend the hose sharply; otherwise, it may be damaged.
5) Loosen the hose clamp, and disconnect the hose.
6) Remove three pump bracket mounting bolts, and remove
the pump together with the pump
dam~er.
..
,,"
"
L2-612
Fig. 18
INSPECTION
1) Connect the leads to the harness connector, and apply a
12-volt power supply to check whether the pump operates.
a. Keep the battery apart from the pump as far as possible.
b. Be sure to turn the 12 V supply ON and OFF on the
battery side.
c. Do not run the pump for a long time under non-loaded
condition.
10
INSTALLATION
1 ) If the pump and damper have been removed from the
pump bracket, tighten the mounting bolts to the specified
torque_
2) Install the hose using the same procedure as that ex-
plained in "Fuel Filter".
3) Install the pump bracket in position to the vehicle body,
and secure it with bolts.
Use care not to drop the spacer of the cushion rubbe.r.
4) Install the hose.
5) Connect the pump harness connector.
6) Run the pump and check for fuel leaks.
o
L2-613
Fig. 19