Subaru XT 1988 Service Manual page 1243

ALARM at ignition
switch OFF
Operation of function
button
Operation of
"R ESET" switch
BODY ELECTRICAL SYSTEM 6-2
• If the preset alarm time is reached while the ignition switch is OF F and the ignition switch is
turned to ON within 20 seconds after the alarm time, the buzzer sounds and the sign"
"»)"
flashes till the 20-second period terminates.
ON
IGN
OFF
ON , . . - - - - . . ,
Alarm I
OFFI
I
I,_~
_ _ - 20 seconds - - - - . :
I
I
Alarm time
• When any of the function buttons are depressed, the buzzer sounds for 0.05 seconds,
indicating that the signal has been accepted.
• If the "RESET" switch is kept ON for 1.2 second, the buzzer sounds for 0.05 seconds.
REMOVAL AND INSTALLATION
(3) Disconnect the connector and take out the unit.
(4) To replace bulbs, remove five screws on the back side
case.
1) Control & display unit
(1) Pry out the cover beside the unit and remove screw in
the opening.
(2) Using screwdriver, slightly pry the unit up, being
careful not to damage instrument panel.
~,--
_ _ [ ' __ 'Ii\ ..
L
~ DDDDDD~
[
L6-476
Fig. 38
L6-477
Fig. 39
(5) Installation is in the reverse order of removal.
33