Subaru XT 1988 Service Manual page 1254

6-2
BODY ELECTRICAL SYSTEM
CONNECTION
Wiper intermittent control unit
o
OFF
IN T
LOW
HIGH
Fig.
66
Radio
REMOVAL AND INSTALLATION
RADIO BODY
1) Take off floor mat of driver's side and draw out feeder
cord connectors from left side of center under portion of
instrument panel.
Feeder cord con nectar
I
. '
' , '
.
.
-
, ' , , '
L6·1499
Fig.
67
44
Intermittent
Wiper motor
connector
_l~TO@
' @ TO@)
--~
Wiper motor
L6·1498
2) Disconnect feeder cord connectors.
3) Take out clock.
4) Remove fitting screws, and slightly pull out radio along
with bracket.
5) Disconnect electric connectors fr'om the back side of
radio, and take out radio along with- antenna feeder cord and
bracket.
6) Remove screws and separate bracket from radio.
7) Installation is in the reverse order of removal.
ADJUSTMENT
1) Setting push button .
• Other than ETR (Electronic tuning radio)
There are five push buttons, so five stations are selected as
follows.
(1) Select a station by turning the turning dial.
(2) Pull the push button and push it back, and then the
push button is kept set at the station required.