Subaru XT 1988 Service Manual page 1060

4-7 AIR CONDITIONING SYSTEM
Condenser Fan Assembly
REMOVAL AND DISASSEMBLY
1) Disconnect battery negative terminal.
2) Remove pulser.
3) Remove the bolts from upper side of fan shroud.
I
Il
L4-1566
Fig. 79
4) Raise the car.
5) Disconnect the fan motor connector, and remove the bolt
from lower side of fan shroud.
Sub fan shroud
Main fan shroud
L4-1567
Fig. 80
6) Lower car to the floor.
7) Remove condenser fan assembly.
8) Remove fan motor and fan from shroud.
Fan and fan motor are balanced and must not be separated.
38
INSTALLATION
Installation is in the reverse order of removal.
Tightening torque:
Fan motor ASSY to shroud:
5 - 10 N·m (0.5 - 1.0 kg-m, 3.6 - 7.2
ft-Ib)
Condenser fan shroud to body:
5 - 10 N·m (0.5 -1.0 kg-m, 3.6 -7.2 ft-Ib)
Flexible Hose
With the following cautions, replace flexible hoses with new
ones if they are damaged or swollen.
(1) The flexible hoses should be free from twists and
tension after they have been connected.
(2) The flexible hoses must not be bent forcibly.
REMOVAL
1) Disconnect battery negative terminal.
2) Discharge refrigerant.
3) Remove low pressure hose.
(1) Remove hose attaching bolts from compressor side.
Plug the opening to prevent foreign matter from getting in.
(2) Disconnect the connector at evaporator unit.
Fig. 81