Subaru XT 1988 Service Manual page 1136

DOORS AND WINDOWS
5-2
L5-438
Fig.
41
When ma.king through-hole into adhesive layer and cutting
the adheSive,
be
careful not to damage interior and exterior
parts.
INSTALLATION
1) Removing gum rubber and spacer stopper.
(1) After cutting layer of adhesive, remove remaining
gum rubber on body.
(2) Remove remaining spacer stopper. At this time, also
remove two-sided tape from spacer stopper completely.
2) Finishing adhesion surface on body side.
Using a cutter knife, etc., cut layer of adhesive sticking to
body and finish it into a smooth surface of about 2 mm
(0.08 in) in thickness.
2 mm (0.08 in)
L5-223
Fig. 42
Take extra care not to cause damage to body paint.
3) Cleaning body surface.
(1) Thoroughly remove chips, dirt and dust from body
surface.
21
(2) Clean body wall surface and upper surface of layer
of adhesive with a solvent such as alcohol or white
gasoline.
4) Pasting spacer stopper.
Put new spacer stopper at places where it was removed.
Spacer
Spacer
Stopper
L5-224
Fig. 43
Remove tack paper from back of spacer stopper and stick it to
body positively.
5) Positioning glass.
(1) Mount glass on body.
(2) Adjust position of glass so that gap between body and
glass is uniform on all sides.
(3) Put matching mark on body and glass in several
places.
6) Cleaning glass.
(1) Dismount glass from body.
(2) Clean surface of glass to be adhered with alcohol or
white gasoline.
7) Application of primer.
(1) Using a sponge, apply primer to part of glass to be
adhered.
(2) Apply primer to part of body to be adhered.
Glass side
Body side
L5-225
Fig.
44