Subaru XT 1988 Service Manual page 1361

WIRING DIAGRAM AND TROUBLESHOOTING
6-3
(2) When chime does not sound, but fasten seat belt warning light turns on;
Turn ignition switch to ON
Confirm that fasten seat belt
position while driver's seat
warning light in telltale turns
belt is not fastened.
*,
on for approx. 6 seconds.
Use circuit tester, and meas· Inspect connector and wire Repair connector and wire.
No
ure whether voltage at ter- between ignition switch and
minal of combination meter combination meter.
is
'2V
or not.
Yes
No
Poor connection between Repair connector, or replace
See if timer discharges inter-
timer and its connector, or
timer.
mittently out-put voltage be-
defective timer.
tween its chime terminals.
Yes
No
I
I
Inspect earth and wire be-
Poor
connection between Repair connector, or wire.
tween combination meter and
timer and its connector, or
chime.
open wire.
~fif discontinuity
I Check for continuity between
I
Repair or replace.
Poor connection or defection
terminal of combination between combination meter
meter and seat belt switch.
and its connector, and be-
tween seat belt switch and
its connector.
Inspect earth wire between
Poor connection between
Repair connector, wire and
combination meter and combination meter and its driver's door switch.
driver's door switch.
connector, or defective wire,
or defective driver's door
switch .
• ,: Never leave the switch in ON position all the way.
89