Subaru XT 1988 Service Manual page 1257

BODY ELECTRICAL SYSTEM 6-2
4) Face inner pipe spring toward the center of car and insert
inner pipe into antenna housing.
5) Temporarily tighten antenna mounting nut.
6) Turn radio switch ON and OFF to ensure antenna rod
extends and retracts properly.
7) Tighten to secure antenna mounting nut.
jJ.,-SPdng
MBatt"Y~_I_in_k
_ _ _ _ ----,
Horn
(Low)
Horn
(High)
Fig.
77
Fuse box
Horn switch
L6-216
For removal of high or low tone horn, disconnect electric
connector with front bumper removed and take out horn by
l...-_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
L_6_-9_ 0 ---l2
removing bolt.
Fig.
75
Digital Clock
REMOVAL AND INSTALLATION
1) Pry out the cover beside the clock display and remove
screw in the opening.
2) Using screwdriver, slightly pry the clock up, being careful
not to damage instrument panel.
L6-556
Fig.
76
3) Disconnect the connector and take out the clock.
4) Installation is in the reverse order of removal.
Horn
All models are equipped with double horns which consists of
high tone and low tone horns.
Horn switch is incorporated in steering wheel. When horn
button is pushed down to actuate horn switch regardless of
any position of ignition-starter switch, horn make a sound.
47
For installation, follow the removal procedure in reverse order.
After installing horn, connect electric wire with it by keeping
some slack to prevent wire from disconnecting by its vibration.
Rear Window Defogger
Rear window defogger is actuated when rear window defogger
switch is turned to "ON" with ignition switch "ON". Indicator
light glows when operating rear window defogger.
INSPECTION
1) Start engine, and turn rear defogger switch on.
2) Check
ea~h
heat wire at its center position for disconti-
nuity by setting direct-current voltmeter.
Fig. 78
Fuse
Fusible link
: Battery
1
'-
Rear
window
defogger switch
Voltmeter
A25-397